JIB · Guide and tool
JIB-AR: booking partner payments
Every JIB invoice creates a receivable from a working interest owner. JIB-AR is the other half of billing: booking what partners pay, keeping each partner's balance right, and following up on what's late or disputed.
The JIB-AR cycle
Bill
The JIB posts a receivable for each partner's share of the month's costs.
Receive
Payment arrives by check, ACH or wire, ideally with remittance detail.
Apply
Cash is applied to the partner's open invoices, or held as unapplied.
Reconcile
The JIB-AR subledger ties to the GL, the bank and the JIB register.
Follow up
Aging is reviewed, disputes are worked and late balances are collected.
How partners pay
Check, ACH or wire
The standard case. The remittance should list the invoice numbers being paid and any amounts held back. Without remittance detail, contact the partner before guessing.
Netting against revenue
When the operator also pays the partner revenue, the partner's JIB balance can be deducted from their revenue check, if the JOA, a netting agreement or the partner's election allows it. The entry clears the receivable against revenue payable instead of cash.
Cash calls and prepayments
For drilling and other large AFEs, the JOA may let the operator request advances. Cash received is held as a partner liability, then applied against the partner's JIB as the actual costs are billed.
Short pays and overpayments
A short pay leaves part of an invoice open, usually because the partner disputes specific charges. An overpayment, or cash with no invoice to apply to, is held as an unapplied credit on that partner's account.
Booking the entries
Account names vary by company. The logic doesn't.
| Event | Debit | Credit | Watch for |
|---|---|---|---|
| JIB billed | JIB receivable, by partner | Cost recovery or the cost accounts (partner share) | Receivable total agrees to the JIB register for the month. |
| Payment received | Cash | JIB receivable, by partner and invoice | Applied to the invoices on the remittance, not just the oldest. |
| Netted against revenue | Revenue payable (the partner's) | JIB receivable | Revenue and JIB-AR both reflect it in the same month. |
| Cash call received | Cash | Partner advances (liability) | Tracked by AFE, so it's applied to the right well's costs. |
| Cash call applied | Partner advances | JIB receivable | Unused advances refunded or applied per the JOA after the AFE closes. |
| Overpayment or no remittance | Cash | Unapplied cash, by partner | Cleared within a month or two, not left to age. |
| Short pay | Cash (amount paid) | JIB receivable (amount paid) | The unpaid lines stay open and are logged as disputed. |
Applying cash
- Follow the remittance. Apply to the invoice numbers the partner lists. Apply oldest-first only when your policy allows it and the partner hasn't said otherwise.
- Stay on the right account. Partners with similar names, affiliates and successors after an assignment each have their own account. Never apply one entity's payment to another's balance without documentation.
- Document every short pay. Record the invoice, the well and cost center, the amount held back and the reason the partner gave.
- Don't net without the right to. Confirm the JOA or a netting agreement allows it for that partner and that property.
- Clear unapplied cash fast. Unapplied credits make both the partner's balance and your aging misleading.
Why partners short pay
Ownership
- Billed at the wrong WI
- Costs dated before their interest was effective
- Billed after they assigned their interest
Authority
- AFE never received: they won't pay AFE-billed costs until they have the AFE
- Costs over the approved AFE without a supplement
- Charges on an AFE they went non-consent on
- Capital coded as LOE, or the reverse
Rates and support
- Overhead at a rate that doesn't match the JOA
- Missing invoice backup they've asked for
- Duplicate charges
Research each dispute with AP and the JIB team. If the partner is right, issue the correction on the next JIB. If not, send support and leave the balance open. The capital vs. LOE guide and the COPAS overhead guide cover two of the most common causes.
No AFE, no payment
Many partners won't pay costs billed against an AFE until they've received that AFE, and often not until they've approved it. Their own AP needs the AFE to code and approve the charge, and under most JOAs they have election rights on the operation. If the AFE didn't reach them, the JIB lines for that well sit unpaid however clean the billing is.
Prevent it
- Send the AFE to every working interest owner before the work starts, and before the first JIB that bills it.
- Keep a record of who received each AFE, when, and their election.
- Show the AFE number on every JIB line billed against it, so the partner can match it.
- Send supplemental AFEs as soon as an overrun is expected. The accrual calculator flags committed cost over the AFE.
- After an assignment, send the new owner the open AFEs on their wells.
When a partner holds payment
- Mark the open items "Held – AFE requested", not disputed or delinquent, so aging shows why they're open.
- Send the AFE, and any supplement, with the JIB backup the same day.
- Follow up once they've had time to approve it, then apply the payment to those invoices when it arrives.
- Don't treat the balance as a collection problem until you've confirmed they have the AFE.
Aging and collections
Review partner aging every month. Balances past 90 days need a documented status: in dispute, promised payment, or sent to land or legal for collection.
The JOA and its accounting procedure set the payment due date, any interest on late payments, and the operator's remedies, which can include netting revenue, enforcing the JOA's lien and security provisions, and default provisions. Which remedies apply, and when, depends on the form and how it was negotiated, so involve land or legal before using them.
Partner aging tool
Paste open items from your JIB-AR subledger, straight from Excel: Partner · Invoice no. · Invoice date · Open amount · Status. Status is optional: use "Held – AFE requested" for items a partner is holding until they get the AFE, or "Disputed" with a reason. Use a negative amount for unapplied cash or credits. Items are aged from the invoice date to the as-of date.
Aging by partner
| Partner | 0–30 | 31–60 | 61–90 | 91–120 | Over 120 | Unapplied | Net balance | Held for AFE | Review |
|---|
Month-end reconciliation
- Subledger to GL. The total of all partner balances equals the JIB receivable control account.
- Billing to the JIB register. The month's new receivables equal the partner share on the JIB register.
- Receipts to the bank. Cash applied plus unapplied cash equals JIB deposits for the month.
- Netting to revenue. Amounts netted on the JIB-AR side equal the deductions taken on revenue checks.
- Advances by AFE. Partner advance balances roll forward by AFE: received, applied, refunded.
These steps fit into the "Reconcile and wrap up" phase of the JIB month-end close checklist.
Your data stays in this page: nothing you paste is sent anywhere or saved. The material on this site is general educational information, not legal, accounting or tax advice. Your joint operating agreements, accounting procedures and company policies govern. Sample data uses made-up companies and figures.